Accessories

Measuring cup for accuracy
Our disposable measuring cup is ideal for measuring small liquid volumes. The cup is conveniently attached to the suction bag lid, and the liquid is suctioned into the cup for measurement. Emptying the cup is also easy during a procedure without disconnecting any tubes.
Measuring tolerance is 5ml up to 50ml and 10ml over this. Measuring scale up to 250ml and full capacity is 400ml.
Measuring tolerance is 5ml up to 50ml and 10ml over this. Measuring scale up to 250ml and full capacity is 400ml.

Collection cup for hygiene
The collection cup is designed to collect samples from suctioned liquid with no compromise in hygiene or safety. The sample is collected into a removable sifter inside the cup body. The sifter collects particles larger than 1mm in size and the samples remain isolated before delivery to a laboratory.
After use you can cap the cup to ensure there is no contact with samples or liquid.
After use you can cap the cup to ensure there is no contact with samples or liquid.

Vacuum shift for adaptability
The vacuum shift is used to shift the vacuum between two suction lines or for the simultaneous use of two suction bag systems. The suction canisters can also be easily connected on each side in a serial chain.
Two independent suction lines allow you to use one line and prepare the other one for use without interruption in suction. To change the used suction line just turn the lever of vacuum shift. Vacuum shift can be connected on top of the trolley or in any Serres suction canister bracket.
Two independent suction lines allow you to use one line and prepare the other one for use without interruption in suction. To change the used suction line just turn the lever of vacuum shift. Vacuum shift can be connected on top of the trolley or in any Serres suction canister bracket.

Splash-Vac for spilled liquids
The disposable Serres Splash-Vac can be used to suction liquids from the floor. Simply connect the tubing to the patient connector of the suction bag and you are ready to suction the liquid into the suction bag.

Vacuum source protector
The vacuum source protector prevents the contamination of the hospital’s central vacuum system and suction pump in case of an unpredictable failure of the fluid collection system. The vacuum source protector is designed to shut off the vacuum and prevent the suctioned fluids from entering the vacuum line, thereby preventing costly Operating Room (OR) clean-up and downtime.
The vacuum source protector is fully compatible with the Serres Suction System and optimized to provide steady suction performance and flow rate.
The vacuum source protector is fully compatible with the Serres Suction System and optimized to provide steady suction performance and flow rate.

Catheter holder
Serres catheter holder holds up to 5-7 catheters and can be placed ergonomically within hands reach.
It can be sterilized in hight temperature (121 celcius) steam and it fits all Serres brackets and holders.
It can be sterilized in hight temperature (121 celcius) steam and it fits all Serres brackets and holders.

Collection pouch valve
Serres collection pouch valve allows liquid, but not air, to pass through from the collection pouch ensuring effective suction at the surgical cavity even if two suction tubes are connected to the same suction bag. It also eliminates noise created by air flow passing through the suction tube.